AWS Convergence Technologies, INC

The numbers on the digital display do not match up with the weather conditions outdoors.

An interruption to the system power may have occurred and the digital display may only need to be reset. This is done by momentarily disconnecting the display power connector on the rear of the unit. All indicators on the display will go dark. Then reinsert the power source and check that the Date is correct and that the time being displayed is correct and advancing.

If the display values still do not appear to be correct, it may be necessary to reset the entire system:

Turn the Data Logger or Master Control Unit off using the power switch on the left hand side in the back, with the front of the unit facing you.
Reset the power to the display as outlined above.
After resetting the system components, the logger/MCU unit POWER indicator should be illuminated and the BATTERY LOW or FAULT indicator should not be illuminated.
Check to see that the data seen on the Digital Display is the same as seen on the host computer monitor.